Lexus 53510-33080 Hood Lock Assembly

You can Select Your Vehicle to check if 53510-33080 fits your vehicle.

Routine maintenance involves applying a few drops of light oil or lock lubricant to the hinges and latch assemblies of doors, hood, and trunk (or liftgate) every 3000 miles or every three months. Additionally, lubricate the door latch strikers with a thin layer of grease for reduced wear and improved movement. Use spray-on graphite lubricant to maintain door and trunk (or liftgate) locks.

For latch removal, start by scribing a line around the latch for alignment reference, then remove the plastic cover secured by plastic pins. Take out the retaining bolts holding the hood latch to the radiator support and remove the latch. Disconnect the hood cable from the latch assembly. When installing, follow the reverse process of removal.For cable removal, disconnect the hood cable from the latch assembly and attach thin wire or string to the cable's end. Unclip all remaining cable retaining clips at the radiator support. Remove the plastic inner fender well, driver's side door sill cover, and kick panel. Detach the hood release lever by removing the two mounting bolts. To install, pull the cable and grommet into the passenger compartment until the wire or string is visible. Ensure the new cable has a grommet attached, then transfer the wire or string to the new cable. Pull the wire or string back through the firewall until the new cable reaches the latch assembly. Reinstall the new cable into the hood release lever in the passenger compartment, making sure the cable housing fits the notch in the handle bracket. Complete the installation by following the reverse process of removal.