Lexus 48820-06040 Link Assy, Front Stabilizer

You can Select Your Vehicle to check if 48820-06040 fits your vehicle.

Sway Bar removal requires taking out the steering gear and then extracting the sway bar from the left wheel well. Damage to the sway bar is often due to severe accidents affecting other major components, necessitating professional repair services. For 2008 and later Highlander V6 and 4WD models, as well as 2009 through 2015 RX350 models, the engine/transaxle assembly must be removed to access the sway bar. Begin by loosening the front wheel lug nuts, raising the vehicle, and securely supporting it on jack stands before removing the front wheels. Disconnect the sway bar links by removing the lower nut, and if necessary, the upper nut if the strut is being removed. Detach both sway bar bushing retainers from the subframe, noting that on 2016 and later Lexus models, the right rear exhaust manifold must be removed for sway bar access. While the sway bar is detached, inspect the retainer bushings for cracks or wear and replace them if needed. Check the sway bar link by flipping the ball joint stud side-to-side and measuring the torque reading after tightening the nut. Clean the bushing area of the sway bar with a wire brush, then lubricate the new bushings with vegetable oil, ensuring the slits face the rear of the vehicle during installation. Finally, install the links and tighten the link nuts and retainers to the specified torque.

Detach both stabilizer bar bushing retainers from the subframe. Note that on 2016 and later Lexus models, it may be necessary to remove the right (rear) side exhaust manifold to allow for the stabilizer bar to be removed.

No, the nuts are sold separately

The nuts that are needed are 17mm