Lexus 28800-54020 Battery

You can Select Your Vehicle to check if 28800-54020 fits your vehicle.

Firstly, the process of checking and replacing a battery involves disconnecting the Car Batteries cables, visually inspecting the battery's state of charge, performing an open voltage circuit test, and conducting a battery load test. When inspecting the battery, use a digital voltmeter to measure the battery's voltage, and remove the surface charge before taking accurate measurements. Also, the battery voltage should be around 12.5 to 12.9 volts. If it is lower, charge the battery before proceeding. Next, perform a battery load test using a load tester, following the manufacturer's instructions. Also, Maintain the load for 15 seconds or less and ensure the battery voltage does not drop below 9.6 volts. If the battery is weak, the tool will indicate this. When replacing the battery, disconnect the battery cables, and remove the hold-down clamp, and the battery. Clean or replace the battery tray if necessary. Install the new battery, ensuring it is identical in dimensions, amperage rating, and cold cranking rating. Finally, reconnect the battery cables in the reverse order of removal.

Simply reverse the removal process, making sure to connect the positive cable first and the negative cable last.

It is recommended to wait at least 90 seconds after turning off the ignition switch before disconnecting the negative battery cable.

You should remove the battery for cleaning, loosen the cable clamp bolts, and remove the negative cable first. Then, clean the cable clamps with a battery brush and warm water and baking soda solution.

Clean cable clamps and terminals with a warm water and baking soda solution, avoiding solution entry into the battery. Inspect and tighten hold-down clamp bolts. Corroded metal parts should be covered with zinc-based primer and painted.

If the booster battery is not maintenance-free, remove the vent caps and cover the vent holes with a cloth.

Make sure that the booster battery has the same voltage as the dead battery in the vehicle.

The average charging time for a trickle charger is 12 to 16 hours. Remove cell caps (if present), cover the holes, and connect the charger cables to the battery posts. Monitor the battery regularly during charging to prevent overheating.

Charge the battery before proceeding.